swayidle - Idle manager for Wayland

NAME SYNOPSIS OPTIONS DESCRIPTION EVENTS SIGNALS EXAMPLE AUTHORS SEE ALSO

The config file to use. By default, the following paths are checked in the following order: $XDG_CONFIG_HOME/swayidle/config, $HOME/swayidle/config Config file entries are events as described in the EVENTS section. Specifying events in the config and as arguments is not mutually exclusive.

-h

Show help message and quit.

-d

Enable debug output.

-w

Wait for command to finish executing before continuing, helpful for ensuring that a before-sleep command has finished before the system goes to sleep.

Note: using this option causes swayidle to block until the command finishes.

-S <seat-name>

Specify which seat to use. By default, if no name is specified, an arbitrary seat will be picked instead.

DESCRIPTION

swayidle listens for idle activity on your Wayland compositor and executes tasks on various idle-related events. You can specify any number of events at the command line and in the config file.

EVENTS

timeout <timeout> <timeout command> [resume <resume command>]

Execute timeout command if there is no activity for <timeout> seconds.

If you specify "resume <resume command>", resume command will be run when there is activity again.

before-sleep <command>

If built with systemd support, executes command before systemd puts the computer to sleep.

Note: this only delays sleeping up to the limit set in logind.conf(5) by the option InhibitDelayMaxSec. A command that has not finished by then will continue running after resuming from sleep.

after-resume <command>

If built with systemd support, executes command after logind signals that the computer resumed from sleep.

lock <command>

If built with systemd support, executes command when logind signals that the session should be locked

unlock <command>

If built with systemd support, executes command when logind signals that the session should be unlocked

idlehint <timeout>

If built with systemd support, set IdleHint to indicate an idle logind/elogind session after <timeout> seconds. Adding an idlehint event will also cause swayidle to call SetIdleHint(false) when run, on resume, unlock, etc.

All commands are executed in a shell.

SIGNALS

swayidle responds to the following signals:

SIGTERM, SIGINT

Run all pending resume commands. When finished swayidle will terminate.

SIGUSR1

Immediately enter idle state.

EXAMPLE

swayidle -w \

			timeout 300 ’swaylock -f -c 000000’ \
			timeout 600 ’swaymsg "output * dpms off"’ \

			resume ’swaymsg "output * dpms on"’ \
			before-sleep ’swaylock -f -c 000000’

This will lock your screen after 300 seconds of inactivity, then turn off your displays after another 300 seconds, and turn your screens back on when resumed. It will also lock your screen before your computer goes to sleep.

To make sure swayidle waits for swaylock to lock the screen before it releases the inhibition lock, the -w options is used in swayidle, and -f in swaylock.

AUTHORS

Maintained by Drew DeVault <[email protected]>, who is assisted by other open source contributors. For more information about swayidle development, see https://github.com/swaywm/swayidle.