solterm − An IPMI Serial over LAN program
solterm
<connection parms> [−e escape_char] [−notencrypted] [−notauthenticated] [−bitrate (9600|19200|38400|57600|115200)] [-alerts (succeed|defer|fail)] [−holdoff] [−ack-retries n] [−ack-timeout microseconds] [−v] [−q]
The solterm program allows a user to make a remote serial connection over IPMI. The requires that the remote system support IPMI 2.0 Serial Over LAN.
<connection parms>
The parameters for the connection depend on the connection type. These are all described in openipmi_conparms (7)
−e escape_char
The character to use to escape, or exit, the program. Entering this chatacter right after a newline is entered causes the program to go into command mode. A single character after this performs a command. The default escape character is "˜" as shown below. Suppported commands are:
˜. |
Terminate the program |
|||
˜B |
Send a serial BREAK over the connection |
|||
˜F |
Flush all buffers |
|||
˜R |
Assert the Ring Indicator (RI) line |
|||
˜r |
Deassert the Ring Indicator (RI) line |
|||
˜D |
Assert DCD and DSR lines |
|||
˜d |
Deassert DCD and DSR lines |
|||
˜C |
Pause the output using CTS |
|||
˜c |
Put CTS under BMC control |
|||
˜? |
Help on escape commands |
|||
˜˜ |
Enter the escape character twice to send it. |
−notencrypted
Do not encrypt the SOL data going over the connection.
−notauthenticated
Do not do integrity checks on the SOL data going over the connection.
−bitrate
Set the bitrate to the given value. The default is whatever the BMC has set it to.
−alerts
This specifies what to do if a
alert that requires a callout occurs on the line.
succeed
specifies that serial/modem alerts are to succeed while SoL is active.
deferred
specifies that serial/modem alerts are to be deferred for the duration of the SoL session.
fail |
specifies that serial/modem alerts automatically fail during the SoL session. This is the default. |
−holdoff
Specifies that CTS, DTR, and DSR are to be deasserted at the start of the SoL session so that the configuration may be modifeid before the handshake is released.
−v |
Be more verbose. Maybe specified multiple time for more output. | ||
−q |
Be less verbose. Maybe specified multiple time for less output. |
openipmi_conparms(7)
None
Darius Davis <[email protected]>