GNUNET-TESTBED-PROFILER(1) General Commands Manual GNUNET-TESTBED-PROFILER(1)
NAME
gnunet-testbed-profiler — profiling driver for the testbed
SYNOPSIS
gnunet-testbed-profiler [−c FILENAME | −-config=FILENAME] [−e COUNT | −-num-errors=COUNT] [−H FILENAME | −-hosts=FILENAME] [−h | −-help] [−L LOGLEVEL | −-loglevel=LOGLEVEL] [−l LOGFILE | −-logfile=LOGFILE] [−n | −-non-interactive] [−p COUNT | −-num-peers=COUNT] [−v | −-version]
DESCRIPTION
gnunet-testbed-profiler is a command line profiling driver for the testbed.
OPTIONS
−c FILENAME |
−-config=FILENAME
Use the configuration file FILENAME.
−e COUNT | −-num-errors=COUNT
Tolerate COUNT number of continuous timeout failures.
−H FILENAME | −-hosts=FILENAME
Name of the file with the login information for the testbed.
−h | −-help
Print short help on options.
−L LOGLEVEL | −-loglevel=LOGLEVEL
Use LOGLEVEL for logging. Valid values are DEBUG, INFO, WARNING and ERROR.
−l LOGFILE | −-logfile=LOGFILE
Configure logging to write logs to LOGFILE.
−n | −-non-interactive
Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.
−p COUNT | −-num-peers=COUNT
Create COUNT number of peers.
−v | −-version
Print GNUnet version number.
SEE ALSO
The full documentation for gnunet is maintained as a Texinfo manual. If the info(1) and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in gnunet(7) and gnunet-c-tutorial(7).
BUGS
Report bugs by using https://bugs.gnunet.org or by sending electronic mail to ⟨[email protected]⟩. GNU September 13, 2014 GNUNET-TESTBED-PROFILER(1)